IMPACT® for Concrete
High Solids / Water-based Urethane Topcoat
Are you ready to save time, money and eliminate the headaches associated with sealing and maintaining concrete floors? IMPACT for concrete is your answer!
IMPACT for concrete is formulated to enhance the look of existing concrete with minimal preparation requirements and reduced ongoing maintenance requirements. With almost no odor, IMPACT may be applied directly to concrete as a durable alternative to polished floors and over stains, dyes, epoxies, and decorative systems as a smooth, ultra-clear, protective topcoat.
Whether it’s water based or high solids urethane UDT has you covered. Click here to compare UltraMax to Impact to see which fits your needs the best.
- Absolutely NO need for diamond pads and NO buffing or burnishing
- Simple, ultra-clear, thin-coat applications
- Super-wetting that enhances and brightens colors
- Non-yellowing and UV stable
- Extreme chemical and abrasion resistance (even to acids)
- Increased slip-resistance available for ramps and stairs
- High-gloss or matte/flat sheen
- Water-based polyurethane–polyurea crosslinking technology
- 50% solids compared to traditional 10-25%
IMPACT Screen & Seal
POLISHED CONCRETE ON STEROIDS
IMPACT Grind & Seal
IT'S OK TO GO GRAY!
IMPACT Grind, Dye & Seal
NATURAL DYED CONCRETE
POLISHED CONCRETE IS GREAT...BUT NOT FOR EVERYONE.
The polishing process is a slow, expensive endeavor that even “the pros” find challenging. Additionally, polished concrete can be expensive to maintain, especially in areas where chemical resistance is needed.
Just one or two grinds and a simple application of IMPACT water-based urethane will yield a high shine that compares to a polish. However, IMPACT for concrete will be more acid and chemical resistant without the need for a “polish guard” that requires buffing and frequent reapplications.
ARE YOU SICK OF TRADITIONAL CONCRETE SEALERS?
One coat of IMPACT for concrete will brighten and enhance your concrete floors more than any acrylic floor sealer. Try our Matte version which doesn’t change the look of the concrete but provides all of the same chemical and abrasion resistance as the glossy version!
IMPACT Coverage Rates
STANDARD KIT Coverage Rates (approximate)
GLOSS: Spray or T-bar/Back-roll = 250-400 Sq. Ft. Rolling method = 150-250 Sq. Ft.
MATTE: Spray or T-bar/Back-roll = 350-600 Sq. Ft. Rolling method = NOT RECOMMENDED
CONTRACTOR KIT Coverage Rates (approximate)
GLOSS: Spray or T-bar/Back-roll = 500-800 Sq. Ft. Rolling method = 300-500 Sq. Ft.
MATTE: Spray or T-bar/Back-roll = 700-1200 Sq. Ft. Rolling method = NOT RECOMMENDED
BULK KIT Coverage Rates (approximate)
GLOSS: Spray or T-bar/Back-roll = 1500-2400 Sq. Ft. Rolling method = 900-1500 Sq. Ft.
MATTE: Spray or T-bar/Back-roll = 2100-3600 Sq. Ft. Rolling method = NOT RECOMMENDED